POWER
The Original Cry Baby® can be powered by
one 9 volt battery (accessed via the bottom of the pedal), a Dunlop ECB003 AC
adapter (ECB003E in Europe) or a Dunlop
DCB10 DC Brick power supply.
SETUP INSTRUCTIONS
• Run a shielded instrument cable from your
guitar to the GCB95’s Instrument jack.
• Run another shielded instrument cable
from the GCB95’s Amplifier jack into
your amplifier input.
• Turn on the amplifier and begin playing.
• To turn the pedal on/off, push the toe of
the pedal down until you feel a “click”.
• By rocking your foot back and forth on
the pedal, you can change the effect that
the Original Cry Baby has on the tone of
your instrument instantaneously.
SPECIFICATIONS
Impedance
Input 800 kΩ
Output 10 kΩ
Filter Parameter
Low Pass 350 Hz ~ 450 Hz
High Pass 1.5 kHz ~ 2.5 kHz
Maximum Level
Input -8.0 dBV
Output +10 dBV
Maximum Gain
Heel Down +19.5 dB
Toe Down +19 dB
Signal to Noise Ratio*
Heel Down 98 dBV
Toe Down 89 dBV
Current Draw 900µA
*OdBV = 1VRMS, A-weigh